Structural stability, durability, low maintenance costs and choice of design features are offered by Cemco's Series 400. This system meets the needs of schools, hospitals and top quality office areas.
Check These Series 400 Features
- Wide choice of baked enamel or vinyl coated steel snap-in panels
- Choice of 24" or 48" modular patterns.
- 100% non progressive, totally demountable and economical to relocate.
- Each panel individually removable for access to wiring and utilities in 2-1/2" wall cavity.
- Choice of base, cornice and door designs.
- Structural capability of 22 foot height in gymnasium for factory areas.
Architectural Specifications:
General: Furnish battenless movable partitions as manufactured by Cemco Inc. Greensboro North Carolina and installation by an authorized Cemco distributor in accordance with this section of the Specifications and applicable drawings.
Materials: (a) Galvanized studs shall be 18 gauge equivalent metal thickness, punched for passage of wiring, set in single track at floor and double channel at ceiling . (Alternate: studs set in recessed, 4" deep, 22 gauge, baked enamel, steel base and 2-1/4" recessed steel cornice.) Studs shall have continuous groove for insertion of steel panels
(b) Panels shall be 22 gauge baked enamel or vinyl covered steel finish, laminated to 1/2" or 5/8" thick gypsum board with continuous flanges for insertion into studs to form single joint. Panel widths to be 24" or 48" as specified.
(c) Window frames shall be knockdown type of anodized aluminum with snap-in vinyl glass retainers to accommodate 1/8" or 1/4" glass.
(d) Doorframes to be 16 gauge, knockdown type reinforced for 1-1/2 pair of 4-1/2"x4-1/2" hinges and ASA universal strike.
(e)Doors to be 1-3/4 " thick steel with 20 gauge face or 1-3/4" thick wood with corresponding hinge and strike cutouts.
(f) Base shall be 4" rigid vinyl, snap-on type, or 4" vinyl glue-on base or recessed baked enamel steel base.
Construction: (a) partitions components shall assemble into a rigid construction and shall be free of exposed screws or rivets. All units shall be removed from either side without disturbing adjacent units. All door units and windows shall be interchangeable with panel units. Three way or four way intersections shall be made at any point without regard to module.
(b) Studs shall be located on 24" on centers. Panels shall be applied vertically in 24" or 48" widths and shall be held in place by CEMCO battenless clips space 18" on center.
Workmanship: Partitions shall be install in accordance with manufacturers specifications and shall be plumb, neat in appearance and free from defects. Hardware shall be adjusted and left in proper working order. All rubbish and cartons shall be removed and the job shall be left broom clean.
